Garage door springs: Springs act as a counterbalance to the weight of the door, and stretch or torque to provide enough force to move the door. There are three types of springs: extension springs, torsion springs and EZ-set torsion springs. Your garage door might need new springs if its alignment is off or if you raise the door halfway and it can’t stay up on its own.


Before setting the last panel in the tracks, set the power unit on the actual frame and slide it in the ends. Hardened screws are used to attach the center bracket (Image 1). They are a different type screw — they are tougher and will last a lot longer. Make sure the bracket is level (to the eye) when installed and leave the bracket a little loose so adjustments can be made. Fasten down all the hinges (Image 2).
Install the vertical roller tracks first by wrapping the curved lip around the rollers. The top of these tracks should be approximately 8 in. below the top of the top section. Wait to install the upper tracks until this step is complete. Check the level of the top section to make sure the tops of the vertical roller tracks are level with each other. The bottom of the roller tracks should be at least 1/8 in. off the concrete floor. After leveling and mounting these tracks, install the upper roller (horizontal) tracks.
I spoke to Phil at my Home Depot. He explained that they had parts available online or he could arrange for a person to come and do the job for me. I chose the second option and he said I would most likely hear from the contractor on Monday and they would arrange an actual date for the repair. They called Sunday and we made an appointment for Monday between 11AM and 1PM and They contacted me at about 11:10 to tell me they would arrive in about 15 minutes. They arrived right on time and finished the job in about an hour or so. I was very impressed with the cleanup and they also lubricated all moving parts on the door before they left. I was extremely impressed with both the installer and also very happy that I went to Home Depot to ask for advise. Thank you for your choice in a very good contractor for my installation. Read less
Garage door manufacturers typically produce garage doors fitted with torsion springs that provide a minimum of 10,000 to 15,000 cycles and are guaranteed for three to seven years. One cycle is a single opening and closing sequence. Most manufacturers offer a 30,000 cycle spring. However, it is important to remember that if the weight of the garage door is increased by adding glass, additional insulation, or even several coats of paint, the life of the torsion spring may be greatly reduced. Additionally, springs at highly humid environments, such as coastal regions tend to have a significantly shorter cycle life, due to the corrosive cracking.
The E900 HARDWARE SSL-1P Garage Door Security Slide The E900 HARDWARE SSL-1P Garage Door Security Slide Bolt protects your padlock against bolt-cutting tools and even allows for the use of a second padlock. It can be installed on either side of your garage door fence gate or small warehouse door. Easy DIY installation with minimal tools required.  More + Product Details Close
If you have a steel door, but want the look of a wood one, it is not necessary to change your entire garage door. Often, it may be possible to mimic the look of wood with skillful painting. Your local home improvement store may be able to provide good advice about the type of paint and brushes needed to mimic the look of wood for your particular door material.
I spoke to Phil at my Home Depot. He explained that they had parts available online or he could arrange for a person to come and do the job for me. I chose the second option and he said I would most likely hear from the contractor on Monday and they would arrange an actual date for the repair. They called Sunday and we made an appointment for Monday between 11AM and 1PM and They contacted me at about 11:10 to tell me they would arrive in about 15 minutes. They arrived right on time and finished the job in about an hour or so. I was very impressed with the cleanup and they also lubricated all moving parts on the door before they left. I was extremely impressed with both the installer and also very happy that I went to Home Depot to ask for advise. Thank you for your choice in a very good contractor for my installation. Read less
Step 5: Check for loose hardware, and tighten as needed. On swing-up doors, check the plates where the spring is mounted to be sure the screws are tight, and tighten any loose screws. On roll-up doors, check the hinges that hold the sections of the door together; tighten any loose screws, and replace any damaged hinges. Sagging at one side of the door can often be corrected by servicing the hinges. If a screw hole is enlarged, replace the screw with a longer one of the same diameter, and use a hollow fiber plug, dipped in carpenters' glue, with the new screw. If the wood is cracked at a hinge, remove the hinge and fill the cracks and the screw holes with wood filler. Let the filler dry and then replace the hinge. If possible, move the hinge onto solid wood.
Since we help service “do it yourselfers,” our site includes “How To” videos that show you how to perform different types of maintenance and repairs to your garage door. These videos are easy to follow and offer step-by-step tips for each repair job.  These DIY videos are further proof that there’s really no better resource for DIY garage door repair.

Because your garage door is a major entryway to your home, it is important to keep it in good working order for your own safety, security, and convenience. Choosing the right style and appropriate materials will lessen the amount of repairs that may arise. Additionally, investing in regular maintenance can be cost-effective in the long run. If your garage door is in need of major repair, it is best to call a professional garage door repair company for assistance. Typically, the company will charge for at least one hour for making a service call. However, the benefits of a professional repair job can well outweigh any costs, as a professional can ensure the safety, security, and proper operation of your garage door.

In Tampa, Clearwater, St Petersburg, Lakeland & New Port Richey Metro Area all garage doors must be permitted and meet stringent wind-code requirements. If you have a garage door installed in your home that is not permitted or does not meet these requirements, it could invalidate your homeowners insurance. Choose a local company that is an expert in hurricane garage doors.
The garage door is the gateway to your home. By choosing an Overhead Door™ residential garage door, you are doing more than making a home improvement investment. You are making us a part of your daily life and relying on us for safety, security and dependable operation. Indulge your sense of design with a garage door that sets your home apart with style, appearance, safety and comfort. With dozens of garage door models to choose from, the Overhead Door™ brand provides style and design options to fit every home. ​
You'll never ask yourself that question again. Just look at your phone to know for sure. Most smart garage door openers will tell you if it's open or shut. They'll send a message every time your garage door is opened or closed too, if you like. Electric garage door openers provide a huge amount of convenience and safety. Imagine you're in a hurry, it's raining out, you pull out of the garage then press the button on your garage door opener remote. The garage door closes, and you didn't have to get out of your car.
×