Re-tensioning a Garage Door Repair Lantana TX spring is a crucial task that requires careful attention to safety and proper technique. Garage door springs are under high tension and can be dangerous to work with if not handled correctly.

Follow these detailed steps to safely re-tension a garage door spring:

Step 1: Gather Necessary Tools and Equipment
Before you begin, ensure you have the following tools and equipment:

  • Safety goggles
  • Leather gloves
  • Adjustable wrenches
  • Winding bars (steel rods)
  • Tape measure
  • Ladder
  • Socket set
  • Safety cable (optional, for extension springs)

Step 2: Understand the Types of Garage Door Springs
There are two main types of garage door springs: extension springs and torsion springs. Extension springs are typically located above the tracks on either side of the garage door, while torsion springs are mounted horizontally above the door and are under higher tension. It’s important to identify the type of springs your garage door has before proceeding.

Step 3: Release Existing Tension (Torsion Springs Only)
If you have torsion springs, you must first release the existing tension before making any adjustments. Follow these steps:

  1. Open the garage door completely.
  2. Disconnect the garage door opener from the door.
  3. Use winding bars to unwind the tension from the torsion spring. Insert the winding bars into the winding cones on each side of the spring and turn them slowly to release the tension. Do this gradually and with caution.

Step 4: Measure and Document
Measure the distance between the winding cones or the number of turns you release from the torsion spring. This information is crucial for properly re-tensioning the spring later.

Step 5: Adjust Tension
Re-tensioning torsion springs can be hazardous and is recommended for experienced individuals. If you’re not comfortable doing this, consider hiring a professional technician. If you choose to proceed, follow these steps:

  1. Place the winding bars back into the winding cones.
  2. Begin winding the spring by turning the winding bars in the opposite direction from when you released tension. Use the measured distance or number of turns from step 4 as a guide.
  3. Wind the spring slowly and evenly, maintaining an equal number of turns on each side of the spring. Use caution, as the spring will become tighter as you wind it.

Step 6: Check Balance
After re-tensioning the spring, manually raise and lower the garage door to check its balance. The door should stay in place when lifted to different heights. If the door feels heavy or imbalanced, you may need to adjust the tension further.

Step 7: Secure Cables and Hardware
If you have extension springs, ensure that the safety cables are properly installed and secured to prevent the springs from flying off if they break. These cables run through the springs and are attached to the wall or ceiling.

Step 8: Test the Door
Test the garage door’s operation by opening and closing it using the opener and manual operation. The door should move smoothly and without any unusual noises. If you notice any issues, stop using the door and consult a professional.

Step 9: Regular Maintenance
Regularly inspect your garage door springs for signs of wear, rust, or damage. Lubricate the springs, hinges, and other moving parts to ensure smooth operation.

Step 10: Safety First
Always prioritize safety when working with garage door springs. If you’re unsure about any aspect of re-tensioning, it’s best to consult a professional technician who has experience in handling garage door springs.

Re-tensioning a Garage Door Repair Lantana TX spring requires a good understanding of the specific type of spring your door has and a careful approach to ensure your safety. If you have any doubts or concerns, it’s recommended to seek the assistance of a professional garage door technician.

Lantana Gates & Garage Doors

1180 Central Way, Lantana, TX 76226, United States

1-940-400-3038