Programming a Genie Garage Door Repair Alpharetta GA opener can vary depending on the specific model you have.

In this guide, I will provide a general overview of the steps involved in programming a Genie garage door opener. Please note that these instructions may not be applicable to every Genie model, so it’s important to consult your owner’s manual for model-specific instructions.

  1. Clear previous programming:
    • Locate the “Learn” or “Program” button on your Genie garage door opener. It is usually located on the back panel or near the light bulb.
    • Press and hold the “Learn” or “Program” button for about 10 seconds until the indicator light on the opener starts blinking or goes out. This action clears any previous programming.
  2. Choose a remote control button:
    • Decide which button on the remote control you want to program to operate your Genie garage door opener. This button will be used to open and close the door.
  3. Program the remote control:
    • Press and release the “Learn” or “Program” button on the Genie opener. The indicator light should blink or stay lit.
    Option 1: Rolling code remotes:
    • Press and release the desired button on the remote control. The indicator light on the opener should flash or go out to confirm the programming.
    • Press the remote button again to test if the opener responds by operating the garage door.
    Option 2: Dip switch remotes:
    • Open the remote control to access the dip switches.
    • Set the dip switches on the remote to match the dip switch settings on the Genie opener.
    • Close the remote control.
    • Press the remote button to test if the opener responds by opening or closing the garage door.
  4. Program additional remote controls:
    • If you have multiple remote controls, repeat the steps above for each additional remote control you want to program.
  5. Program a wireless keypad (if applicable):
    • Open the keypad cover and locate the “Learn” or “Program” button on the keypad or the Genie opener.
    • Press and release the “Learn” or “Program” button on the opener, then enter your desired PIN on the keypad.
    • Press the “Program” or “Enter” button on the keypad. The indicator light on the opener should blink or go out to confirm programming.
    • Test the keypad by entering your PIN and pressing the “Enter” button. The garage door should open or close.
  6. Test the programming:
    • Stand inside your garage and press the programmed button on the remote control or the PIN on the keypad.
    • The garage door should open or close in response to your command.
    • If the door doesn’t operate as expected, repeat the programming steps and ensure that you follow each step correctly.

Remember, these instructions provide a general guideline for programming a Genie Garage Door Repair Alpharetta GA opener. For model-specific instructions or troubleshooting, always consult your owner’s manual or contact Genie customer support for assistance.

Alpharetta Garage Door Repair

5200 Avalon Blvd building 5000, Alpharetta, GA 30009

1-678-379-5834