Genie Garage Door Repair Wise County TX openers are designed to provide convenience and security to homeowners. However, there are times when you may need to reset your Genie garage door opener, such as when you have a new remote or keypad, or if you’re experiencing issues with your opener.

The process for resetting a Genie garage door opener will depend on the specific model you have. In this article, we’ll provide you with a general guide to resetting a Genie garage door opener, which should work for most models.

However, we recommend consulting your owner’s manual or contacting Genie customer service for specific instructions.

Step 1: Disconnect Power

Before attempting to reset your Genie garage door opener, you must disconnect power to the unit. This can be done by unplugging the opener from the electrical outlet, or by turning off the circuit breaker that powers the opener.

Step 2: Locate the Learn Button

Next, you’ll need to locate the “Learn” button on your Genie garage door opener. The Learn button is typically located on the same side as the antenna, and it may be labeled as “Program,” “Set,” or “Learn.”

Step 3: Press the Learn Button

Once you’ve located the Learn button, press and hold it down until the indicator light on the opener turns off. This may take several seconds. Once the light turns off, release the button.

Step 4: Press the Remote Button

Next, press the button on your remote control that you want to program to the opener. Hold the button down until the indicator light on the opener starts flashing.

Step 5: Test the Remote

After the indicator light starts flashing, test the remote by pressing the button again. The door should open or close, indicating that the remote has been successfully programmed to the opener.

Step 6: Repeat for Additional Remotes

If you have additional remotes or keypads that you want to program to the opener, repeat steps 4 and 5 for each device.

Step 7: Reset the Keypad (Optional)

If you have a wireless keypad that needs to be reset, you can do so by entering the default code for your Genie garage door opener. The default code is usually located on the keypad itself or in your owner’s manual. Once you’ve entered the code, press the “Program” button on the keypad and then the “Learn” button on the opener.

Step 8: Reconnect Power

After you’ve finished programming your remotes and keypads, you can reconnect power to the Genie garage door opener. Plug it back into the electrical outlet or turn the circuit breaker back on.

Step 9: Test the Door

Finally, test the garage door to make sure it opens and closes properly with all of the remotes and keypads that you’ve programmed.

In summary, resetting a Genie Garage Door Repair Wise County TX opener involves disconnecting power, locating the Learn button, pressing it to put the opener into programming mode, pressing the remote button to program it, testing the remote, and resetting the keypad if necessary. It’s important to consult your owner’s manual or contact Genie customer service for specific instructions and to follow all safety precautions when working with garage door openers.

Wise County Door and Gate

1-940-304-0821