When I noticed that the glass in my garage door window was broken, I knew I had to replace it as soon as possible. I was hesitant to call a professional because I thought it would be an easy job that I could handle myself.

So, I did some research and watched some tutorials to gather all the necessary information and tools to get started. Here’s what I did in reference to Garage Door Repair North Miami FL.

First, I put on my safety goggles and work gloves to protect myself from any sharp edges or broken glass. Then, I used a screwdriver to remove any screws or hardware holding the window frame in place. I was careful not to damage the frame or surrounding materials as I did this.

Next, I used a putty knife to remove any glazing compound or putty around the edges of the frame. This was a bit challenging as the putty was quite old and hard, but I was patient and persistent. Once I removed the glazing compound, I gently pushed on the glass from the inside of the frame to loosen it. It was a bit scary as the glass was sharp and could easily cut me, but I was careful and managed to remove it without any incidents.

After removing the glass, I cleaned the frame and removed any remaining pieces of glass or putty. I then measured the dimensions of the opening where the glass was removed using a measuring tape. It was important to measure both the height and width of the opening to ensure an accurate measurement.

Once I had the measurements, I took them to a glass supplier and ordered a replacement piece of glass. I made sure to order the correct type of glass for my garage door window, which was tempered glass.

When I received my replacement glass, I put on my work gloves and safety goggles again. I used a putty knife to apply a small amount of glazing compound or putty to the edges of the frame where the glass would be installed. This helped hold the glass in place and prevent drafts.

Then, I gently placed the replacement glass into the frame, making sure it was centered and flush with the edges of the frame. I used glazing points to hold the glass in place, inserting them into the frame with a screwdriver.

Once the glass was secure, I applied more glazing compound or putty around the edges of the frame to seal the glass in place. I used a putty knife to smooth out the compound and create a clean, uniform seal around the edge of the frame.

Finally, I reattached any screws or hardware that were removed in the first step to secure the window frame back into place. I made sure the frame was level and secure, and that the glass was flush with the frame.

To clean up any excess glazing compound or putty that may have oozed out during the installation process, I used a putty knife or scraper to remove any excess material.

In conclusion, as per Garage Door Repair North Miami FL, replacing the glass in a garage door window was a bit challenging, but I managed to do it successfully. It was important to be patient, cautious, and meticulous throughout the process to avoid any accidents or damages. With the right tools, knowledge, and preparation, anyone can replace the glass in their garage door window and improve the appearance and functionality of their garage door.

Denzel’s Garage Door of North Miami

1750 NE 124th St #5, North Miami, FL 33181, United States

305-676-7411